Titanium 64-5 Filamet™ - The Virtual Foundry

Titanium 64-5 Filamet™

  • $ 704.00


Titanium 64-5 Filamet™ contains around 80% metal. Filamet™ enables any Fused Filament Fabrication 3D printer to produce metal objects. Once fired in a kiln, the result is 100% metal.

3D Printer setup: Visit our Use Instructions page for full printing, sintering and polishing guidelines.

Temperature: 205-215°C (401-419°F)

Set print bed to 50°C (122°F) (optional)

Tip: Put a layer of blue painters tape on the print bed. Our metal filament Filamet™ has great adhesion to the bed. 

Speed: 30mm/sec (1800mm/min) to start.

Layer Height: Many slicers lay down an extra wide first layer to get good adhesion to the bed. This is not a problem unless the first layer is very thin. With traditional PLA, it will simply squeeze out at the sides. Filamet™ is a metal filament that is is more viscous which slows this process. If the printer nozzle seems clogged, it may be that the nozzle is too close to the bed on the first layer. Once dialed in, some users are printing down to a layer height of 0.1mm. 

Nozzle: 0.6mm or larger, standard stainless steel.

Reel Placement: Reducing friction and pull on Filamet™ during printing is important. Try hanging the filament reel just above the printer.

No sintering trials have been conducted on this material. Check The Virtual Foundry's Use Instructions page for guidelines to get started with the sintering process where needed.

 Note: All sales final except in cases of defective product.


We Also Recommend