H13 Tool Steel Filamet™ - Discontinued

  • $187.00


H13 Tool Steel Filamet™ is discontinued. Very limited quantities remain. This item will be replaced by M300.

Specs: This filament comes in 0.5kg and 1kg spools. It contains 86.8% metal and has a density of 3.56g/cc.

High Compatibility: This Filamet™ enables any open-architecture Fused Filament Fabrication 3D printer to produce metal objects. Even works in 3D printing pens!

Easy to Print: All you need is an open architecture 3D printer, a 0.6mm hardened steel nozzle, and a model to print. Print like regular PLA. Place your spool so that the filament coming off is going straight into the extruder. The flow rate in your slicer may need to be adjusted up to 135%. Little to no warping occurs during printing.

Advanced Properties: Filamet™ is less hygroscopic than regular PLA. Filament dryers have adverse affects on Filamet™. Spools should not be dried.

Fully Sinterable Metal Filament: Once fired in a sintering furnace, the result is 100% metal. 

Debind
RAMP 33°C (60°F)/hour to 204°C (400°F)
HOLD for 2 hours
RAMP 17°C (30°F)/hour to 427°C (800°F)
HOLD for 6 hours
RAMP 33°C (60°F)/hour to 538°C (1000°F)
HOLD for 2 hours

Sinter
RAMP 333°C (600°F)/hour to 1260°C (2300°F)
HOLD for 4 hours
RAMP 111°C (200°F)/hour to 593°C (1100°F)
No HOLD

Crucible packing instructions are found here, in the section that describes debinding and sintering Stainless Steel Filamet™.

Special Qualities: High strength, wear resistant.

Used For: This filament is used for wear resistant and high strength parts.

Eliminate tooling and machining costs for short run manufacturing, prototyping, and one-off metal part needs.

Note: All sales final except in cases of defective product.

Made In America


Customer Reviews

Based on 2 reviews Write a review