Inconel® 718-34 Filamet™ - The Virtual Foundry

Inconel® 718-34 Filamet™

  • $ 223.00


Inconel® 718-34 Filamet™ contains around 86% metal and has a density of 3.98g/cc. Filamet™ enables any Fused Filament Fabrication printer to produce metal objects. Once fired in a sintering furnace, the result is 100% metal.

What you'll need to print:
* An FFF/FDM 3D printer
* Stainless or hardened steel nozzle sized at 0.6mm (MK8 and MK10 varieties in the shop)
Filawarmer

* Blue painters tape for your print bed. Glue sticks also work on glass print beds

What you'll need to debind & sinter:
* Any Kiln or Furnace that can hold the sinter temperature of your desired material. (Sinter temps listed here.) The Virtual Foundry sells two sizes of kiln: Starter and Pro
* Crucible (a few varieties in the shop)
* Sintering Refractory Ballast - Sapphire3D Steel Blend
* Sintering Carbon

Slicer Setup: Start with a basic PLA profile for your printer. Change the nozzle temperature to 225°C (437°F). Optionally, set the print bed to 40-50°C (104-122°F). Set the flow rate to 135%. Adjust settings from there as needed.

Tip: Put a layer of blue painters tape on the print bed. Filamet™ has great adhesion to the bed.

Nozzle: 0.6mm or larger, standard stainless steel.

Spool Placement: Reducing friction and pull on Filamet™ during printing is important. Try hanging the filament spool just above the printer.

Polishing: Visit our Use Instructions page for polishing guidelines.

Certified Sintering Service Bureau
 

Eliminate tooling and machining costs for short run manufacturing, prototyping, and one-off metal part needs.

Note: All sales final except in cases of defective product.

Inconel® is a registered trademark of Special Metals Corporation.

Made In America


We Also Recommend